D-Link DWS-4000 Series, Cli Command Reference

Page: 399 / 566

391
DiffServ Show Commands
This set of commands consists of service addition/removal.
The CLI command root is
service-policy
.
service-policy
This command attaches a policy to an interface in the inbound direction. The
<policyname>
parameter is the name of an
existing DiffServ policy. This command causes a service to create a reference to the policy.
no service-policy
This command detaches a policy from an interface in the inbound direction. The
<policyname>
parameter is the name of
an existing DiffServ policy.
D
IFF
S
ERV
S
HOW
C
OMMANDS
Use the DiffServ show commands to display configuration and status information for classes, policies, and services. You can
display DiffServ information in summary or detailed formats. The status information is only shown when the DiffServ
administrative mode is enabled.
Note: This command effectively enables DiffServ on an interface in the inbound direction. There is no separate
interface administrative 'mode' command for DiffServ.
Note: This command fails if any attributes within the policy definition exceed the capabilities of the interface. Once
a policy is successfully attached to an interface, any attempt to change the policy definition, that would result in a
violation of the interface capabilities, causes the policy change attempt to fail.
Format
service-policy in <policymapname>
Modes • Global Config
• Interface Config
Note: Each interface can have one policy attached.
Note: This command causes a service to remove its reference to the policy. This command effectively disables
DiffServ on an interface in the inbound direction. There is no separate interface administrative 'mode' command
for DiffServ.
Format
no service-policy in <policymapname>
Modes • Global Config
• Interface Config