D-Link DWS-4000 Series, Cli Command Reference

Page: 390 / 566

D-Link Unified Switch CLI Command Reference
382
© 2009 D-Link Corporation. All Rights Reserved
diffserv
This command sets the DiffServ operational mode to active. While disabled, the DiffServ configuration is retained and can
be changed, but it is not activated. When enabled, DiffServ services are activated.
no diffserv
This command sets the DiffServ operational mode to inactive. While disabled, the DiffServ configuration is retained and can
be changed, but it is not activated. When enabled, DiffServ services are activated.
D
IFF
S
ERV
C
LASS
C
OMMANDS
Use the DiffServ class commands to define traffic classification. To classify traffic, you specify Behavior Aggregate (BA),
based on DSCP and Multi-Field (MF) classes of traffic (name, match criteria)
This set of commands consists of class creation/deletion and matching, with the class match commands specifying Layer 3,
Layer 2, and general match criteria. The class match criteria are also known as class rules, with a class definition consisting
of one or more rules to identify the traffic that belongs to the class.
The CLI command root is
class-map
.
class-map
This command defines a DiffServ class of type match-all. When used without any match condition, this command enters the
class-map mode. The
<class-map-name>
is a case sensitive alphanumeric string from 1 to 31 characters uniquely
identifying an existing DiffServ class.
The class type of
match-all
indicates all of the individual match conditions must be true for a packet to be considered a
member of the class.This command may be used without specifying a class type to enter the Class-Map Config mode for an
existing DiffServ class.
Format
diffserv
Mode Global Config
Format
no diffserv
Mode Global Config
Note: Once you create a class match criterion for a class, you cannot change or delete the criterion. To change
or delete a class match criterion, you must delete and re-create the entire class.
Note: The class-map-name 'default' is reserved and must not be used.
Note: The CLI mode is changed to Class-Map Config or when this command is successfully executed.
Format
class-map match-all <class-map-name>
Mode Global Config