CyberOptics SE500ULTRA, Hardware Manual

Page: 144 / 188

Chapter 3 : Replacing Components and Preventive Maintenance
134 SE500
ULTRA
Hardware Manual
Preventive Maintenance
Cleaning the Encoder Strips
Encoder strips are located on the gantry along the X and Y axes. There are two encoder strips for
the X axis. (Left to right)
➢
To clean the encoder strips
1. Turn off all electrical power to the system. For more information, refer to the section
“ Shutting Down the System ” on page 52.
2. Open the SE500
ULTRA
hood.
3. Make sure all motion has stopped.
4. Locate the encoder strips on the X- and Y-axes.
5. Remove any coarse or abrasive particles with clean, dry, compressed air.
Warning:
Make sure the system power is turned off and locked off before working inside the
hood. Gantry motion can pinch or sever objects in its path.
Caution: The encoder strips can be damaged by abrasive substances and solvents. Follow the
procedure below to avoid scratches or other damage to the encoder strips.