CyberOptics SE500ULTRA, Hardware Manual

Page: 49 / 188

CyberOptics Corporation 39
Connecting to a Network
Connecting to a Network
Connect the SE500
ULTRA
to the network using the Ethernet port on the rear electrical panel. The
network port can be used for 10Base-T or 100Base-T installations. You will need assistance from
your network administrator to complete this procedure.
➢
To connect the SE500
ULTRA
to a network
1. Shut down Windows and then push the E-Stop button on the front of the unit.
2. Turn off all electrical power to the system. For more information, refer to “ Shutting Down the
System ” on page 52.
3. Connect the network cable to the Ethernet connection located on the rear electrical panel.
Figure 25. Network Connection
Configuring the LAN Connection
Use the Windows network tools to complete the Ethernet configuration. This is typically done by
a network administrator and includes the following:
●
Adding the protocol
●
Assigning the IP address
●
Configuring the Domain Name System (DNS)
Ethernet connection
Back Electrical Panel