CyberOptics SE500ULTRA, Hardware Manual

Page: 54 / 188

Chapter 2 : Installation
44 SE500
ULTRA
Hardware Manual
5. Set the high trigger set point by pressing and to cycle through the values.
6. Stop on the value and wait 5 seconds to end programming mode.
➢
To set the operating mode
The operating mode should be set to Window Comparator Mode by default. If not, change the
mode as follows:
1. Press one time until option 1 appears.
2. Wait three seconds to enter mode 1.
3. With ou1 displayed, press to choose Cnp.
( ou1 = output 1, Cnp = Window Comparator Mode)
4. Press to select
End
.
➢
To change the display color
1. Press six times until option 6 appears.
2. Wait three seconds to enter mode 6.
3. Press to cycle through the color options:
2-r: On=Red, Off=Green
2-9 : On=Green, Off=Red
1-r : On=Red, Off=Red
1-9 : On=Green, Off=Green
off : Turn off display
4. Press to select
End
.
➢
To lock/unlock the display controls
1. Press and hold .
2. Press to lock ( Loc ).
3. When locked, press and hold .
4. Press to unlock (
UnC
).
i
Note
: if
H-1
or
h-1
appears instead, change the operating output mode as described in “ To set the
operating mode ” below.