CyberOptics SE500ULTRA, Hardware Manual

Page: 38 / 188

Chapter 2 : Installation
28 SE500
ULTRA
Hardware Manual
Positioning / Leveling the SE500
ULTRA
Adjust the height of the system to align with incoming and outgoing conveyor sections. System
height can be configured at a standard height or can be lowered 5 cm (2 inch.) by repositioning
the leveling foot block. Both methods are described in the following section.
Standard Conveyor Height
The standard height configuration allows the SE500
ULTRA
conveyor to be positioned from 91–104
cm (36–41 inch) high.
➢
To adjust the system height (standard height)
1. Ensure that the floor is free of debris and the area provides adequate clearance on all sides of
the unit.
2. Push the SE500
ULTRA
unit into position, lining up the front rails of the incoming and
outgoing conveyor sections.
3. To adjust the leveling feet, loosen the locking nut with a wrench and then turn the
adjustment nut.
●
Turn the nut clockwise to raise the unit
●
Turn the nut counter-clockwise to lower the unit
Figure 13. Leveling Foot
4. Use a level or machine height measurements to make sure that the system is level.
5. Manually slide a panel through the incoming and outgoing conveyor sections to make sure
that the SE500
ULTRA
conveyor rail is properly aligned. The panel should pass from the
upstream conveyor through the SE500
ULTRA
system and on to the downstream conveyor
without any resistance.
6. After adjusting the leveling feet, tighten the locking nuts.
i
Note:
Do not bolt the SE500
ULTRA
conveyor to incoming and outgoing conveyor sections.
Vibrations from other machines may impact SE500
ULTRA
performance.
Locking nut
Adjustment nut