CyberOptics SE500ULTRA, Hardware Manual

Page: 78 / 188

Chapter 3 : Replacing Components and Preventive Maintenance
68 SE500
ULTRA
Hardware Manual
Cleaning Inside the Enclosure
➢
To clean inside the enclosure
1. Turn off all electrical power to the system. For more information, refer to the section
“ Shutting Down the System ” on page 52.
2. Lift the system hood.
3. Make sure all motion has stopped.
4. Use a dry cloth to wipe debris off of the inside of the hood, conveyor rails, the gantry, etc.
Cleaning Main Electronics Panel
➢
To clean the main electronics panel
1. Turn off all electrical power to the system. For more information, refer to the section
“ Shutting Down the System ” on page 52.
2. Open the hood on the SE500
ULTRA
.
3. Make sure all motion has stopped.
4. Remove two screws that secure the lower front panel to the machine frame.
5. Using clean, dry, compressed air, remove the dust buildup from the main electronics panel.
Keep away from the system so the dust will not get into the electronics panel.
6. Replace the lower font panel.
7. Close the SE500
ULTRA
hood.
Warning: Make sure the AC main circuit breaker is turned OFF and power is disconnected
from the mains before starting on any procedure.
i
Note: For residue such as solder paste, remove the substances from inside the system with clean,
dry cloth.