CyberOptics SE500ULTRA, Hardware Manual

Page: 68 / 188

Chapter 3 : Replacing Components and Preventive Maintenance
58 SE500
ULTRA
Hardware Manual
➢
To replace DIN rail-mounted components
1. Turn off all electrical power to the system. For more information, refer to the section
“ Shutting Down the System ” on page 52.
2. Open the hood on the SE500
ULTRA
3. Make sure all motion has stopped.
4. Gain access to the main electrical panel by removing two screws that secure the lower front
panel to the machine frame.
5. Identify the part to replace (see Figure 32 on page 59) and disconnect the wires from the
terminals.
6. If present, remove attaching screws from the component.
7. Insert a flat blade screwdriver underneath the component and press down on the tab to
release it from the rail.
Figure 31. DIN Rail Mounting
8. Hook the component onto the upper edge of the DIN rail and press downward to latch it onto
the rail.
Releasing from DIN rail
Latching onto DIN rail
Caution:
The Middleman board contains components that can be damaged by static electricity.
Use a ground strap when handling the board to prevent damage to sensitive components.