CyberOptics SE500ULTRA, Hardware Manual

Page: 62 / 188

Chapter 2 : Installation
52 SE500
ULTRA
Hardware Manual
Shutting Down the System
➢
To shut down the system
1. Stop the inspection process.
2. Press the E-Stop button.
3. Close the inspection application.
4. On the taskbar, click
Start
and then click
Shut Down
to shut down the system processor.
5. Turn off the power switch on the front of the unit. This removes all power from the system
with the exception of the processor power.
Figure 29. Shutting Down the System
➢
To remove power entirely
1. Turn off the power switch on the front of the unit.
2. On the rear of the machine, turn the AC main circuit breaker to OFF.
Caution:
Turning off power at the power switch does not remove power from the processor. The
AC main circuit breaker must be turned OFF to remove power completely from the machine.
Power Switch