CyberOptics SE500ULTRA, Hardware Manual

Page: 53 / 188

CyberOptics Corporation 43
Configuring the Pressure Gauge Display
Configuring the Pressure Gauge Display
By default, the pressure gauge on the outside of the system is set to:
●
Units of Measure: PSI
●
Trigger point range: 80–100 PSI
●
Output mode: Window Comparator Mode (Cnp)
You can change settings such as the units of measure, the trigger points, and the display color.
General programming instructions
1. Press and hold for 3 seconds to enter programming mode.
2. Press to cycle through the main programming modes:
1
: Operating mode
2
: Output (Normally Open or Normally Closed)
3
: Units of measure
4
: Display refresh rate
5
: Output response
6
: Display color
3. With the mode number shown in the display, wait 3 seconds to select the mode.
4. When a mode is selected:
●
Press to cycle through the options.
●
Press to end programming mode.
➢
To change the Units of Measure
1. Press three times until option 3 appears.
2. Wait three seconds to enter mode 3.
3. Press to cycle through the options for Pressure Units:
-PA: Pascal (negative) for vacuum sensors
PA : Pascal
-bA : Bar (negative) for vacuum sensors
bA : Bar
-H9 : mmHg (negative) for vacuum sensors
H9 : mmHg
iH : in.Hg
-F9 : kgf/cm
2
(negative) for vacuum sensors
F9 : kgf/cm
2
PS : PSI
4. Press to select
End
.
➢
To set the pressure alarm trigger points
1. Press . Set mode will appear for 1 second followed by A-1 (Low set point).
2. Set the low trigger set point by pressing and to cycle through the values.
3. Stop on the value and wait 5 seconds to end programming mode.
4. Press .
Set
mode will appear for 1 second followed by
b-1
(High set point)