Cisco BPX 8650, Installation And Configuration Manual

Page: 37 / 606

xxxv
Cisco BPX 8600 Series Installation and Configuration
Release 9.3.30, Part Number 78-12907-01 Rev. E0, May 2005
About This Guide
Organization
•
Chapter 16, “Checking and Powering-Up,” explains how to check that you are ready and then
perform the initial power-up.
• Chapter 17, “Initial BPX 8600 Node Configuration,” guides you through the initial node
configuration that must be done before you can set up network management.
•
Chapter 18, “Configuring Trunks and Adding Interface Shelves,” describes how to configure trunks
and add interface shelves.
•
Chapter 19, “Configuring Circuit Lines and Ports,” describes how to configure circuit lines and
ports.
•
Chapter 20, “Configuring Network Management,” describes the initial procedures to set up a
permanent network management station.
• Chapter 21, “Configuring ATM Connections,” explains how to establish ATM connection services
by adding ATM connections between ATM service interface ports in the network using ATM
standard UNI 3.1 and Traffic Management 4.0.
•
Chapter 22, “Configuring Frame Relay to ATM Network and Service Interworking,” describes
Frame Relay to ATM interworking.
• Chapter 23, “Configuring BXM Virtual Switch Interface,” describes the BXM Virtual Switch
Interface (VSI) and provides configuration procedures.
•
Chapter 24, “Configuring BXM Virtual Trunks,” describes the Broadband Switch Module (BXM)
virtual trunks.
•
Chapter 25, “Configuring SONET Automatic Protection System,” contains a description and
configuration information for the SONET Automatic Protection System (APS).
•
Chapter 26, “Configuring BME Multicasting,” presents an overview of multicasting, a description
of the BME card used on the BPX switch for multicasting for PVCs, and configuration instructions.
• Chapter 27, “Alarms and Statistics,” describes some of the tools provided for detecting and
identifying network and equipment problems that are available to the network operator.
•
Chapter 28, “Troubleshooting,” describes periodic maintenance procedures and general
troubleshooting procedures.
• Chapter 29, “Replacing Parts,” describes the replacement of major BPX switch components.
•
Chapter 30, “BPX Node Specifications,” lists information for the BPX system specifications.
•
Chapter 31, “BPX Switch Cabling Summary,” specifies the cabling required to install the BPX
switch.
•
Chapter 32, “AT3-6ME (T3 to T2) Interface Adapter,” describes the AT3-6ME Interface Adapter,
sometimes referred to as the T3-T2 Interface Adapter.
• Appendix A, “Upgrade Information,” provides special upgrade information.
A glossary and an index is also included.