Cisco BPX 8650, Installation And Configuration Manual

Page: 304 / 606

20-4
Cisco BPX 8600 Series Installation and Configuration
Release 9.3.30, Part Number 78-12907-01 Rev. E0, May 2005
Chapter 20 Configuring Network Management
Configuring the BPX Switch LAN and IP Relay
During the configuration of BPX switch interfaces, you must make sure that the following parameters
are consistently set with your local area network (Ethernet LAN):
• The BPX switch IP address
•
SNMP parameters
•
Network IP address
To set the parameters, use the BPX switch commands as described in Table 20-1. On BPX and IGX
switches, use these commands to configure the nodes for operation with Cisco WAN Manager.
For more information on how to use these commands, refer to the Cisco WAN Switching Command
Reference or the Cisco WAN Switching SuperUser Command Reference . SuperUser commands may be
used only by authorized personnel with great care.
Figure 20-2 Cisco WAN Manager Physical LAN and IP Relay Network
Table 20-1 BPX Switch Commands
Name Description
cnflan Configures the BPX switch BCC LAN port IP address and subnet mask. This
SuperUser command is necessary only for nodes or shelves in which the LAN port
is actually connected to a physical Ethernet LAN as shown in Figure 20-2.
cnfsnmp Configures the following SNMP Get and Set community strings for the BPX
switch:
•
Get Community String = public
•
Set Community String = private
• Trap Community String = public
cnfnwip Configures the virtual IP network (IP relay) among BPX switches. This is a
Superuser command.
cnfstatmast Defines the IP address for routing messages to and from the Statistics Manager in
CiscoView.
Cisco
WAN Manager
NMS
Ethernet LAN
204.179.31.XX
IP relay
network
204.179.55.XX
28810
BPX
switch
IGX
switch
MGX
8220
IGX
switch
IGX
switch