Cisco BPX 8650, Installation And Configuration Manual

Page: 460 / 606

25-14
Cisco BPX 8600 Series Installation and Configuration
Release 9.3.30, Part Number 78-12907-01 Rev. E0, May 2005
Chapter 25 Configuring SONET Automatic Protection System
APS Command Summary
APS Command Summary
Commands to support APS are listed in Table 25-7, and defined in more detail in the Cisco WAN
Switching Command Reference where you will find thorough information on each of these commands,
as well as other commands not listed here.
Manual Switch
Wait To Restore
Reverse Request
Do not Revert
No Request
Table 25-6 K1 Switching Conditions (continued)
APS K1 Command Precedence
Table 25-7 APS Commands
Name Description
New Commands Added for Management of APS
cnfcdaps slot Sets APS options on the card.
addapsln slot1.port1 slot2.port2 protocol Adds APS.
delapsln slot.port Deletes APS.
dspapsln Displays status of APS line pairs.
switchapsln slot.port (option 1...6, S) Controls the APS user switching interface.
cnfapsln slot.port Configures the APS parameters on a line.
New Commands for Card Redundancy for APS 1+1
addcdred Adds redundancy across two cards.
dspcdred Displays the redundant cards.
delcdred Deletes redundancy configuration for cards.
switchcdred Switches active and redundant cards.
Commands modified for use with APS
cnfbkcd Specifies that the APS options are modified.
dspalms Adds a row for “APS Alarms” that lists Minor and
Major APS alarms.
dspcd Displays front and back card APS attributes. For
the front card, displays that card supports APS
1+1 and APS 1:1. For the back card, displays if
back card is a redundant back card, and if so, the
slot number of the redundant back card. Also,
displays APS mismatch conditions.
dspsv3 Displays APS alarms pending.
dsplog Displays APS alarms.