Cisco BPX 8650, Installation And Configuration Manual

Page: 220 / 606

12-4
Cisco BPX 8600 Series Installation and Configuration
Release 9.3.30, Part Number 78-12907-01 Rev. E0, May 2005
Chapter 12 Installing the T3/E3 Cable Management Tray
Raising Tray for Access to PEMs
Raising Tray for Access to PEMs
You should raise the tray only when necessary to access the Power Entry Modules (PEMs), typically for
replacement or to install a second PEM. Figure 12-4 shows the tray in the raised position.
To raise the tray to provide access to the PEMs, use the following procedure:
Step 1
Remove the securing screws as necessary.
Step 2 With two hands, pull the tray towards yourself and up.
Step 3
Raise the tray to the upper position and lower it onto the upper slots.
Figure 12-4 Cable Management Tray in Raised Position
Installing BXM T3/E3 Cable Bracket
To attach the BXM T3/E3 cable bracket to each BXM T3/E3 card as shown in Figure 12-5, use the
following procedure:
Step 1 Remove the bracket from the kit.
Step 2
Place the bracket in position as shown.
Step 3
Screw in and tighten the captive screw.
Step 4
Insert one end of the cable tie through the hole in the bracket.
H10009