Canon imageRUNNER ADVANCE C255 Series, Service Manual, Page: 916 / 987

13.
Turn ON the main power switch.
Setting after Installation
1. Connect the power plug of the host machine to the
outlet.
2. Turn ON the main power switch.
3. Check the model of the Card Reader in service mode
(Level 1).
• COPIER > OPTION > ACC > CR-TYPE (Default: 0
"Card Reader-F1")
4. In service mode (Level 2), set the number of cards
(the number of departments) (1 to 1000) that can be
used for the Card Reader to any value.
• COPIER > OPTION > FNC-SW > CARD-RNG
5. Enter the card number which is the smallest of the
card numbers to be used (1 to 2001) in service mode
(Level 1).
• COPIER > FUNCTION > INSTALL > CARD
Starting from the entered card number, the number
of cards set in step 4 can be used.
6. Turn OFF and then ON the main power switch to
enable the setting value.
7. Insert a card with a card number that has been
registered, and check that the machine operates
properly.
NOTE:
Perform the following operations to change the number of
cards (the number of departments) after it has been set.
In that case, counter information for each department is
reset.
• Service mode (Level 1): COPIER > FUNCTION >
CLEAR > CARD
• Turn OFF and then ON the main power switch to
enable the settings.
• After that, perform the setup procedure again from
step 3.
9. Installation
905