Canon imageRUNNER ADVANCE C255 Series, Service Manual, Page: 798 / 987

COPIER (Service mode for copier) > OPTION (Specification setting mode) > USER
FREG-SW 2 For R&D
IFAX-SZL 2 Setting of IFAX send size limit
Detail To set for restricting data size at the time of IFAX transmission that does not go through the server.
With the setting to restrict the data size, there will be #830 error in the case of sending data that
exceeds the upper limit value.
In the case that the data goes through the server, the size of transmission data is always restricted.
Use Case
Upon user's request
Adj/Set/Operate Method
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
Display/Adj/Set Range
0 to 1
0: Limited, 1: Not limited (Restriction applies when data goes through the server.)
Default Value
1
Additional Functions
Mode
Function Settings> Send> E-Mail/I-Fax Settings> Maximum Data Size for Sending
Supplement/Memo Set the upper limit value for transmission data size in Settings/Registration menu.
IFAX-PGD 2 Set page split TX at IFAX Simple mode TX
Detail To set to enable/disable split-data transmission on a page basis in the case that the transmission
size in IFAX Simple mode exceeds the upper limit value.
Use Case
Upon user's request
Adj/Set/Operate Method
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
Caution
In the case to enable split-data transmission, be sure to get approval from the user by explaining
the following:
- No guarantee for page order on the reception side
- There is a possibility of interruption of other received jobs between pages.
Display/Adj/Set Range
0 to 1
0: Disabled, 1: Enabled
Default Value 0
Related Service Mode COPIER> OPTION> CLEANING> W-CLN-P
Additional Functions
Mode
Function Settings> Send> E-Mail/I-Fax Settings> Maximum Data Size for Sending
Supplement/Memo Set the upper limit value for transmission data size in Settings/Registration menu.
MEAPSAFE 2 Setting of MEAP safe mode
Detail *Operation on this item is restricted by the setting of [Restrict Service Representation Access].
To set safe mode for MEAP platform.
MPSF is displayed on the Control Panel in safe mode.
In safe mode, MEAP application is stopped while just the system application, which starts with
initial state, is activated. Logs for cause analysis of MEAP failure can be obtained.
Use Case
Perform system recovery processing when MEAP platform fails to be activated due to resource
confliction between MEAP applications, service registration or use order.
Adj/Set/Operate Method
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
Display/Adj/Set Range 0 to 1
0: Normal mode, 1: Safe mode
Default Value 0
8. Service Mode
787