Canon imageRUNNER ADVANCE C255 Series, Service Manual, Page: 854 / 987

COPIER (Service mode for copier) > COUNTER (Counter mode) > DRBL-1
REG-DR-U 1 Registration Drive Unit parts counter
Detail Registration Drive Unit
1st line: Total counter value from the previous replacement
2nd line: Estimated life value
Use Case When checking the consumption level of parts/replacing the parts
Adj/Set/Operate Method To clear the counter value: Select the item, and then press Clear key.
To change the estimated life: Select the item, enter the value, and then press OK key.
Caution Clear the counter value after replacement.
Display/Adj/Set Range 0 to 99999999
Unit sheet
Default Value 0
Amount of Change per
Unit
1
WST-TNR 2 Waste Toner Container parts counter
Detail Total counter value from the previous replacement
The counter value is automatically cleared when it is replaced while the Waste Toner Container
preparation warning message or waste toner full message is displayed.
If it is replaced while neither message is displayed, it is necessary to clear the counter value
manually.
Use Case When checking the consumption level of parts
Adj/Set/Operate Method To clear the counter value: Select the item, and then press Clear key.
Caution Clear the counter value if it is replaced while neither the Waste Toner Container preparation
warning message nor waste toner full message is displayed.
Display/Adj/Set Range 0 to 99999999
Unit sheet
Default Value 0
Amount of Change per
Unit
1
PT-DR-Y 1 Drum Unit (Y) parts counter
Detail 1st line: Total counter value from the previous replacement
2nd line: Estimated life
The value stored in the Drum Unit Memory PCB is displayed.
It cannot be changed manually.
Use Case
When checking the consumption level of parts/replacing the parts
Adj/Set/Operate Method To clear the counter value: Select the item, and then press Clear key.
To change the estimated life: Select the item, enter the value, and then press OK key.
Display/Adj/Set Range 0 to 99999999
Default Value 0
PT-DR-M 1 Drum Unit (M) parts counter
Detail 1st line: Total counter value from the previous replacement
2nd line: Estimated life
The value stored in the Drum Unit Memory PCB is displayed.
It cannot be changed manually.
Use Case When checking the consumption level of parts/replacing the parts
Adj/Set/Operate Method To clear the counter value: Select the item, and then press Clear key.
To change the estimated life: Select the item, enter the value, and then press OK key.
Display/Adj/Set Range 0 to 99999999
Default Value 0
8. Service Mode
843