Canon imageRUNNER ADVANCE C255 Series, Service Manual, Page: 796 / 987

COPIER (Service mode for copier) > OPTION (Specification setting mode) > USER
PCL-COPY 2 Set of PCL COPIES command control method
Detail To set the binder control method of COPIES command with PCL.
Select whether to use the control method of Canon-made PCL or use the same control method of
non-Canon-made PCL.
Use Case Upon user's request
Adj/Set/Operate Method 1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
Display/Adj/Set Range 0 to 65535
0: Control method of Canon-made PCL (following the value of COPIES command that is specified
for each page to control on a page basis)
1: Control method of non-Canon-made PCL (handling the value of COPIES command, which is
specified for page 1 at the time of Collate mode, as bind figure while the value of COPIES command
for the next page or later is invalid. Same control applies as Canon-made PCL at the time of non-
sorted mode)
2 to 65535: For future use
Default Value 0
BCNT-AST 1 Set of box print charge target job
Detail *Operation on this item is restricted by the setting of [Restrict Service Representation Access].
To set the job type that advances the count in box print with NE Controller (ASSIST).
Use Case
When switching the job type that is subject to counting of the box print with NE Controller
Adj/Set/Operate Method
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
Display/Adj/Set Range
0 to 1
0: PDL job, 1: Copy job
Default Value
0
PRJOB-CP 2 Set count TX at RX/report print
Detail To set to enable/disable a page-basis count pulse transmission to the charging management
device at the time of reception print or report print.
Use Case Upon user's request
Adj/Set/Operate Method 1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
Display/Adj/Set Range 0 to 1
0: No transmission, 1: Transmission
Default Value 0
Supplement/Memo Charging management device: Coin Manager, Non-Canon-made control card
DFLT-CPY 1 Setting of color mode for copy
Detail To set the default color mode for copy operation.
To reflect the change, it is necessary to initialize the default settings of copy function in one of the
following two ways.
- Settings/Registration> Function Settings> Copy> Change Default Settings> Initialize
- Main Menu> Copy> Logo icon in upper right of the screen> Change Default Settings> Initialize
Use Case Upon user's request
Adj/Set/Operate Method
1) Enter the setting value, and then press OK key.
2) Initialize the default settings of copy function.
Caution
Be sure to initialize the default settings of copy function after change.
Display/Adj/Set Range
0 to 2
0: Based on Auto/ACS/Printer Driver settings, 1: Color mode, 2: Black mode
Default Value
It differs according to the location.
Additional Functions
Mode
Function Settings> Copy> Change Default Settings> Initialize
Function Settings> Copy> Select Color Settings for Copy> Use Auto (Color/Black & White)
8. Service Mode
785