Canon imageRUNNER ADVANCE C255 Series, Service Manual, Page: 759 / 987

COPIER (Service mode for copier) > OPTION (Specification setting mode) > NETWORK
NW-WAIT 2 Set connect wait at deep sleep recovery
Detail To set whether to send wakeup notice after the time set in Settings/Registration menu has elapsed
when recovering from deep sleep.
When 0 is set, wakeup notice is sent after "Waiting Time for Connection at Startup" has elapsed.
When 1 is set, wakeup notice is sent when the machine becomes ready for communication.
Use Case When a failure of the device management tool occurs
Adj/Set/Operate Method 1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
Display/Adj/Set Range 0 to 1
0: Wait, 1: Not wait
Default Value 0
Additional Functions
Mode
Preferences> Network> Waiting Time for Connection at Startup
WLAN-USE 2 Setting of wireless LAN invalidation
Detail To set whether to disable the wireless LAN.
Bringing in and installation of the wireless LAN equipment may be prohibited depending on user.
In such case, set 0 to prevent the wireless LAN to be used. When 0 is set, [Wireless Connection
Settings] is not displayed in [Settings/Registration].
Use Case When bringing in and installation of the wireless LAN equipment is prohibited
Adj/Set/Operate Method 1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
Display/Adj/Set Range 0 to 1
0: Disabled, 1: Enabled
Default Value 1
Additional Functions
Mode
Preferences> Network> Wireless Connection Settings
WLANPORT 2 Set of port filter at wireless LAN side
Detail *Operation on this item is restricted by the setting of [Restrict Service Representation Access].
To set whether to open all ports at the wireless LAN side.
When 0 is set, only the specific port is opened (filter is enabled).
Set 1 when using an application which uses a port other than the specific port. All ports are opened
(filter is disabled).
Use Case
Upon user's request
Adj/Set/Operate Method
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
Display/Adj/Set Range
0 to 1
0: Open the specific port, 1: Open all ports
Default Value
0
RAW-PORT 2 [For customization]
LINKWAKE 2 Set of deep sleep recovery at link-up
Detail To set whether to recover from deep sleep when link-up (disconnection and then connection of
LAN cable) is detected.
Set 0 if the closest hub or switch chatters at link-up. It can prevent recovery from deep sleep
triggered by chattering.
Use Case When the machine recovers from deep sleep due to chattering of the closest hub or switch
Adj/Set/Operate Method
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
Display/Adj/Set Range
0 to 1
0: Not recovered, 1: Recovered
Default Value
1
WIFIRFCH 2 For R&D
8. Service Mode
748