Canon imageRUNNER ADVANCE C255 Series, Service Manual, Page: 763 / 987

COPIER (Service mode for copier) > OPTION (Specification setting mode) > IMG-SPD
FIX-ROT 1 Idle rotn end temp after small ppr feed
Detail When feeding the small size paper following the large size paper on the Fixing Assembly, the
temperature at both edges of Fixing Film is higher than the center. To prevent the fixing offset or
paper wrinkle, it idles until the temperature becomes the specified value after the small size paper
is fed.
This item is to set the temperature to finish the idle rotation.
When the value is increased, downtime is increased because of prioritizing image quality.
When the value is decreased, downtime is decreased, but uneven gloss occurs.
Use Case - When uneven gloss occurs at paper edge
- When improving productivity
Adj/Set/Operate Method Enter the setting value (switch negative/positive by -/+ key) and press OK key.
Display/Adj/Set Range -2 to 2
-2: -10 deg C, -1: -5 deg C, 0: +/-0 deg C, 1: +5 deg C, 2: +10 deg C
Unit deg C
Default Value 0
Amount of Change per
Unit
5
ARC-INT1 2 Set of ARCDAT interruption interval
Detail To set the number of sheets as the intervals at which ARCDAT control is executed.
When the number of sheets reaches the specified value, ARCDAT control is executed by
interrupting an ongoing job.
If the value is too large, the density of image becomes different before and after the interruption.
If the value is too small, the productivity is lowered.
Use Case Upon user's request
Adj/Set/Operate Method Enter the setting value, and then press OK key.
Display/Adj/Set Range 10 to 500
Unit sheet
Default Value 80
Related Service Mode COPIER> OPTION> IMG-SPD> ARC-INT2
Amount of Change per
Unit
1
ARC-INT2 2 Set ARCDAT exe interval: last rotation
Detail To set the number of sheets which ARCDAT control is not executed, from the start of a job.
ARCDAT control which is supposed to be executed during the specified number of sheets is
executed at last rotation of the previous job. Since the number of interruptions during a job is
reduced, the productivity is enhanced.
However, the number of times of ARCDAT control executed at last rotation might be increased
depending on the print conditions.
Use Case
Upon user's request
Adj/Set/Operate Method
Enter the setting value, and then press OK key.
Caution Do not set a larger value than ARC-INT1.
Display/Adj/Set Range 10 to 500
Unit sheet
Default Value 30
Related Service Mode COPIER> OPTION> IMG-SPD> ARC-INT1
Amount of Change per
Unit
1
8. Service Mode
752