Canon imageRUNNER ADVANCE C255 Series, Service Manual, Page: 455 / 987

E674-0301-07 Fax configuration error
Detection Description It was detected that there was no 1-line Fax Board installed while the IP Fax license was enabled.
Remedy
- Install the Fax Board (1-line) to use the machine as an IP Fax model.
- Uninstall the IP Fax license and install the G3 Fax Board to use the machine as a G3 Fax model.
E713-0000-05 Communication error
Detection Description The operation was not completed although retry of the communication between the host machine
(Dcon) and the Finisher was performed for 3 consecutive times.
Remedy [Remedy] Perform the following in the order while checking whether the error is cleared.
1. Check that the connector of the Interface Harness is not disconnected.
2. Replace the Finisher Controller PCB.
3. Replace the Interface Harness.
E719-0001-00 Error in Coin Vendor.
Detection Description Error in starting of the CoinVendor
- The Coin Vendor, which should have been connected before the power was turned OFF, is not
connected when the power is turned ON.
Remedy Check the connection between charging management equipment and machine, and check that
the Cable is not open-circuit.
Clear the error while the charging management equipment is connected to operate and when
switching to the operation without charging management equipment.
(To prevent the misuse by removing the charging management equipment, this error code is
displayed.)
E719-0002-00 Error in Coin Vendor.
Detection Description Error in IPC when CoinVendor is running.
- In the case of disconnection of IPC or an error in which IPC communication failed to be recovered.
- When disconnection of the pickup delivery signal is detected.
- When illegal connection is detected (short-circuit with Tx and Rx of IPC)
Remedy Check the connection between charging management equipment and machine, and check that
the Cable is not open-circuit.
Clear the error while the charging management equipment is connected to operate and when
switching to the operation without charging management equipment.
(To prevent the misuse by removing the charging management equipment, this error code is
displayed.)
E719-0003-00 Error in Coin Vendor.
Detection Description - In the case of communication error with the coin vendor while obtaining the unit price at start-up.
Remedy Check the connection between charging management equipment and machine, and check that
the Cable is not open-circuit.
Clear the error while the charging management equipment is connected to operate and when
switching to the operation without charging management equipment.
(To prevent the misuse by removing the charging management equipment, this error code is
displayed.)
E719-0004-00 Coin vendor error
Detection Description The coin vendor was connected to a model that does not support the coin vendor
Remedy Cancel the connection of the coin vendor and clear the error.
E719-0031-00 Error in serial communication at the start of the New Card Reader
Detection Description Failure in communication with the serial New Card Reader at start-up.
Remedy - Check if the cable of the serial New Card Reader is disconnected.
- Take out the serial New Card Reader.
- COPIER > Function > CLEAR > CARD
- COPIER > Function > CLEAR > ERR
E719-0032-00 Error in serial communication at the start of the New Card Reader
Detection Description Communication failed in the middle of the operation although communication with the serial New
Card Reader was successful at start-up.
Remedy
- Check if the cable of the serial New Card Reader is disconnected.
7. Error/Jam/Alarm
444