CAE SimuFlite Citation Bravo, Pilot Training Manual

Page: 436 / 718

5B-62
Developed for Training Purposes
Citation Bravo
September 2005
CAE SimuFlite
The BRG 0 knob operates the same
as the BRG O knob and displays
VOR 2, ADF (ADF 2 if aircraft is
equipped with two ADF receivers),
and FMS information via a white
needle with a diamond-shaped head.
PFD Bezel Controller
The PFD bezel controller on the
lower part of each PFD
(Figure 5B-
47)
has three basic functions. An
inclinometer contains a ball in a glass
track that indicates a slip or skid. The
STD (Standard) button returns the
altimeter setting to the standard
value, either 29.92 inHg or 1,013
hPa. The BARO (Barometric) knob
sets the altimeter setting in either
inHg or hPa. When cross-sided
MADC data appears on the PFD, nei-
ther pilot has control over the dis-
played BARO setting from their
respective BARD set knob. Addition-
ally, the BARD set operates indepen-
dent of the display controller, and it
does not require the display controller
to be functional to set data.
Early (Phase 1) PFD bezel control-
lers had the IN/HPA button located
on the bezel, to the left of the incli-
nometer.
MC-800 Multifunction
Display Controller
The MFD controller (see
Figure 5B-
47
) at the forward end of the pedestal
controls the MFD display format,
symbol generator reversion, MFD
dimming, checklist operation,
weather, TCAS, and map inputs.
Through the controller, the pilot can
select map, plan, and/or weather
mode. The controller also allows the
display and scrolling of normal and
emergency checklists. If a symbol
generator fails, reversionary switch-
ing is available through the controller.
The functions and modes on the
MFD are described below:
The MODE selector rotary switch is a
three-position switch (SG1/NORM/
SG2) that selects the symbol genera-
tor modes of operation. The selection
of SG1 or SG2 drives all displays
with the selected symbol generator.
The DIM knob controls the MFD
brightness level. It is concentric with
the mode selector switch. Counter-
clockwise dims the display.
Navigation
The MAP/PLAN, RNG switch, and
the VOR, DAT, and APT buttons are
used to control the display mode,
data, and map/plan ranges.
n
MAP/PLAN toggles between the
map display and the plan display;
the power-up default is the map
view with no weather
n
VOR - controls the display of the
four closest VORs that are not on
the active flight plan list
n
DAT - stands for data and controls
the display of long range naviga-
tion symbols and identifiers
n
APT - controls the display of the
four closest airport locations and
identifiers that are not on the
active flight plan list
n
RNG - is disabled in the weather
(WX) mode and increases or
decreases selected ranges in preset
steps; the selectable ranges are
2.5, 5, 12.5, 25, 50, 100, 200, 300,
and 600 NM.
Weather
The WX button controls weather
radar returns on the MFD map dis-
play. Pressing the WX button with
the PLAN view displayed replaces it
with the MAP view.