93
About System Timing Parameters
The default value for the system timing parameters should be suitable for most applications and will
never need to be changed. There may be for most applications and will never need to be changed.
There may be some changes you will desire to make which will affect the operation of the system
under certain conditions. Any changes made affect all outside lines and all extensions.
Changing System Timing Parameters
The command to change the system timing parameters requires that each setting be entered in
the order shown. If you are modifying only a few of the settings in the list, you should enter the
default value, shown with an “*”, for other parameters which you do not intend to change.
System Timing Parameters
1.
In the programming mode, enter “727”.
727
Delay After Each RS232C Character
This determines the amount of delay inserted after a character is sent across the RS232C port to
the printer or PC. This setting is important only if you directly connect a computer or dedicated
printer to the RS232C port.
2.
Enter the 2-digit code for the character delay.
00
0 milliseconds
* 01
8 milliseconds
02
16 milliseconds
…
99 792 milliseconds
System Timing Parameters
