68
Metering Pulse Frequency
If metering is enabled, you must select either 12 KHz or 16 KHz as the frequency to be detected.
7818
To select 16 KHz as the metering frequency:
In programming mode, enter “7818”. Pause for con
fi
rmation tone.
Hang up or continue with programming.
To select 12 KHz as the metering frequency:
In programming mode, enter “7819”. Pause for con
fi
rmation tone.
Hang up or continue with programming.
7819
Caller ID
If your IPS is equipped with the optional Caller ID feature, this parameter should be enabled to
allow IPS to capture the Caller ID data sent by the Central Of
fi
ce switch between the
fi
rst and
second ring of any incoming call. This information will be output on the RS232C port of the
system to a computer equipped with appropriate translation and display software. The RS232C
port must be in the “Features Mode” to allow the information to be output normally or in the
“System Mode” to allow the information to be transmitted via the CAT interface if your IPS is
equipped with the CAT version of the software (see “RS232C Port – Choosing The Operating
Mode”, page 89 and “Computer Aided Telephony (CAT) Software”, page 91).
7828
To enable Caller ID detection:
In the programming mode, enter “7828”. Pause for con
fi
rmation tone.
Hang up or continue with programming.
To disable Caller ID detection:
In the programming mode, enter “7829”. Pause for con
fi
rmation tone.
Hang up or continue with programming.
7829
Central Offi
ce Lines – Advanced Topics
Chapter
3
- Functions Of IPS System
