Avaya P332G-ML, User Manual

Page: 136 / 254

Chapter 6 CLI – Layer 2
118 Avaya P334T-ML User’s Guide
Note: You must disable Spanning Tree before you can enable redundancy.
The syntax for this command is:
set port redundancy {enable|disable}
Output Example:
P330-N# set port redundancy enable
All redundancy schemes are now enabled
set internal buffering
The
set internal buffering
command allows you to set the size (either
Maximum or Minimum) of the Receive (Rx) buffer allocated to each port of the
specified switch. This command is meaningless when any port of the switch is
operating with flow control ON.
Note: This command is not supported by the P330-ML switches and is used to set
the internal buffering value for the P330 modules in the stack.
The syntax for this command is:
set internal buffering <mod_num> {max|med|min}
Example:
P330-N> set internal buffering 1 max
Done.
set boot bank
Use the
set boot bank
command to configure the software bank from which the
switch will boot at the next boot process. This command should be issued separately
for each switch in the stack using the
session
command.
max Sets the internal receive buffer to its maximum size.
med Sets the internal receive buffer capacity dynamically
min Sets the internal receive buffer to its minimum size (this is the
Default).