Autodesk AUTOSKETCH 8, User Manual

Page: 225 / 400

Placing Text
|
215
and the second specifies the angle. In the case of the Text Rectangle com-
mand, a third point specifies the extent of the text box. You do not have to
use the same snap or lock modifier for these points. For instance, you could
use Gridpoint snap for one point and Endpoint snap for the other.
To add text aligned to two points
1 On the Draw menu, click Text, Point, or click the Text Point button on the
All-In-One toolbar.
2 (optional) On the edit bar, change the font, height, and/or justification.
3 Make sure the Formula check box on the edit bar is not checked.
4 Press and hold CTRL and enter a point for the basepoint of the text.
5 Enter a second point for the angle of the text. The Text Input dialog box
appears.
6 Enter the text. The text edit mode defaults to the last text edit mode used.
To change text edit modes, use the Inplace Edit button on the Text Editor
dialog box to switch to inplace editing or use the Text Editor Dialog
button on the edit bar to switch to text editor mode. For information on
using the Text Editor, refer to page 218.
7 Click OK.
For inplace editing, move the pointer away from the text box and right-
click or use CTRL+ENTER to complete the command.