Audioaccess AVR21EN Installation Instructions Manual Download Page 34

Page: 34 / 222

AVR21ENR1 FEATURE DESCRIPTIONS

NOTES:

• The function names shown here are each button’s function when used with the AVR21EN.

Most buttons have additional functions when used with other devices, and some of these
functions may be assigned to different buttons, depending on which device was selected. The
device name will appear in the upper line of the LCD

Information Display [oval 3]

and the

function assigned to that device will appear in the lower line when the button is pressed. See
section:

AVR21ENR1 Function List

for a list of the functions assigned to each button for each

device type.

• Some buttons have special functions when they are pressed and held for 3 seconds.

• The jack on the upper right side of the remote is reserved for future use. Do not remove the plug

provided or connect any device to the jack.

• The AVR21ENR1 remote control may be programmed to control up to eleven devices. Before

using the remote, it is important to press the

Input Selector [oval 4]

that corresponds to the

device you wish to operate.

• The remote is capable of operating a wide variety of products made by other manufacturers

using control codes that are programmed into the remote’s code library. As described in
sections:

AVR21EN Configuration/Remote Control Setup

and

Programming the

KP21ENR1 Remote Control

it is simple to program the remote to operate your device by

selecting the device type and brand, and then programming the correct set of codes for that
brand.

IMPORTANT NOTE: With the exceptions of the AVR, TV and Game/Cam, the codes output by
the AVR21ENR1 are proprietary Audioaccess IR codes that are received by the AVR21EN and
converted to the actual IR codes for the sources being controlled. These IR codes are output
via emitters connected to the IR

Control Outputs [circle 36]

on the AVR21EN rear panel.

Power Off (All):

Press this button to place the AVR21EN in the Standby mode. Note that this

will turn off the main room functions, but if the Multiroom system is activated, the AVR will
continue to function and the message:

MULTI-ZONE ON

will appear in the

Lower Display

Line [square 34]

on the AVR Front Panel.

Power On (All):

Press this button to turn the AVR on. When properly setup, all common

source components will automatically turn on as well. Press this button to turn on the power
to TV or Game/Cam by first pressing either the

TV [oval 6]

Game/Cam Button [oval 4]

LCD Information Display:

This two-line screen displays setup menus and other information

depending on the commands that have been entered into the remote.

Input Selectors:

Pressing one of these buttons will perform three actions at the same time.

First, if the AVR21EN is not turned on, this will power up the unit. Next, it will select the
source shown on the button as the input to the AVR21EN. Finally, it will change the remote
control so that it controls the device selected. After pressing one of these buttons, you may
need to press the

AVR Button (System Selector) [oval 5]

again to operate some AVR21EN

functions with the remote.

System Selector (AVR Button):

Pressing this button will switch the remote so that it will

operate the AVR21EN's functions (accessing menus, etc). If the AVR21EN is in the Standby
mode, it will also turn the AVR21EN on.