151
KP21R REMOTE CONTROL FEATURE DESCRIPTIONS
NOTES:
• The function names shown here are each button’s function when used with a KP21 Keypad
and AVR21EN Controller (System). Most buttons have additional functions when used with
other devices, and some of these functions may be assigned to different buttons, depending on
which device was selected. The device name will appear in the upper line of the LCD
Information Display [triangle 3]
and the function assigned to that device will appear in the
lower line when the button is pressed. See:
KP21R Remote Function List
for a list of the
functions assigned to each button for each device type.
• Some buttons have special functions when they are pressed and held for 3 seconds.
• The jack on the upper right side of the remote is reserved for future use. Do not remove the plug
provided or connect any device to the jack.
• The KP21R remote control may be programmed to control up to ten devices. Before using the
remote, it is important to press the
Input Selector [triangle 4]
that corresponds to the device
you wish to operate.
• The remote is capable of operating a wide variety of products as configured in the AVR21EN
REMOTE CONTROL SETUP.
The KP21R sends proprietary Audioaccess codes that are
interpreted by the AVR21EN and output as the original manufacturer’s codes through the
respective
Control Out [circle 36]
IR outputs on the AVR rear panel.
• Only the TV, Local 1 and Local 2 devices are controlled directly with the KP21R. Those codes
are programmed in the remote. See section:
Programming the KP21R Remote
Control/Learning Commands
.
1.
Power Off (All):
Press this button to turn the local zone OFF. If the Multiroom system is
active in other zones, including the Main Room, the AVR21EN will continue to function. If the
local zone is the last active zone in the system, the AVR will turn off all common source
components and switch itself to Standby.
2.
Power On (All):
Press this button to turn on the local zone. If any other zone is active, the
local zone will turn on to either the source selected when the zone was turned off or the
source designated in
POWER ON MODE
. If no other zones are active, the AVR21EN will
turn on and Display:
MULTI-ZONE ON
, but will not turn on the Main Room or any other zones.
The AVR will turn all common source components on.
3.
LCD Information Display:
This two-line screen displays remote menus and various
source/function information depending on the commands that have been entered into the
remote.
4.
Input Selectors:
Pressing one of these buttons will turn on the local zone if off. (If the
AVR21EN is off, the press of an input selector will turn the AVR on to MULTI-ZONE ON.) If
the local zone is on, these buttons will select the common sources as connected to the AVR
Source Inputs and switch the remote to control of that device.
5.
TV Mode Select:
Press this button to switch the remote keys to control the local TV or video
display.
6.
Local 2 Select:
Press this Button to control a local source.
Summary of Contents for AVR21EN
