197
4. With the cursor next to
RESTART NETWORK
, press the
Set Button [oval 18]
. The
RESTART
NETWORK
screen will appear. (
Figure 123
)
5. Press
the
▼
/
▲
Navigation Button [oval 16]
to place the cursor next to
YES
. Press the
Set
Button [oval 18]
. The menu will automatically return to the
DIAGNOSTICS
screen.
6. To manually return to
DIAGNOSTICS
, without restarting, position the cursor next to
BACK TO
DIAGNOSTICS
, press the
Set Button [oval 18]
.
7. To return to system mode, press the
Exit Button [oval 17]
.
PROGRAMMING THE KP21R REMOTE CONTROL
The KP21R Zone Remote is setup to control a remote zone in a W.H.E.N. System right out of the
box. System commands such as ON/OFF, Source Select, Volume and other basic system
functions are pre-programmed. Control of common source components is done on a system
basis once
MAIN MENU/REMOTE CONTROL SETUP
has been configured. The system will
recognize button presses from the KP21R and output the appropriate IR commands for the
device selected on the remote.
The KP21R can also be used to control a local TV or Video Display and two local sources such
as a Video Game, or Cable/Satellite Receiver, etc. To control these devices the KP21R must be
manually programmed using the remote’s built-in menu system.
NOTE: There are only three devices that can be configured for direct control using the KP21R
remote. They are TV/Combo, Local 1 and Local 2. These devices will be controlled directly from
the KP21R with their original IR codes. The common sources will be controlled with their original
IR codes, but only when output from the AVR21EN when prompted by the special Audioaccess
codes output by button presses from the KP21R.
TV Setup
To configure the KP21R remote to control a Remote Room TV:
1. Turn on the power to the TV. This is important, as in a later step you will need to see whether
the TV turns off to determine whether the remote has been programmed for the proper
remote codes.
2. Press and hold the
REM MENU Button [triangle 33]
for about three seconds while the
message HOLD BUTTON FOR 3 SECONDS
appears
in the remote’s LCD
Information
Display [triangle 3]
. Release the button when the red light under the
Set Button [triangle
15]
appears. (
Figure 124
)
Figure 124
3. The
remote’s
MAIN MENU/PROGRAM CODE
message will appear in the LCD display and
the
Set Button [triangle 15]
will remain illuminated in red. Press the
Set Button [triangle
15]
to begin the process of selecting a device and locating the proper remote codes. (
Figure
125
)
Figure 125
Summary of Contents for AVR21EN
