Ametek Sorensen Asterion DC ASM, Programming Manual

Page: 98 / 162

Asterion DC Multioutput Series
Programming Manual
M330517-01 Rev C 10-81
Command Description SCPI
SYST:NET:DNS?
Returns the network DNS address for the device. N
SYST:NET:GATE <string>
Sets the network gateway IP address for the device. String is in
the format “NNN.NNN.NNN.NNN” where “NNN” = 0 through
255, inclusive.
N
SYST:NET:GATE?
Returns the network gateway IP address for the device. N
SYST:NET:HOST <string>
Set the network Host Name, a 15-character (maximum)
alphanumeric string.
(Must be limited to 15 characters for LXI compliance)
N
SYST:NET:HOST?
Returns the network Host Name N
SYST:NET:IP <string>
Sets the Primary configuration to STATICIP mode and sets the
network IP address for the device.
String is in the format “NNN.NNN.NNN.NNN”
where “NNN” = 0 through 255, inclusive.
N
SYST:NET:IP?
Returns two IP addresses: the first is the IP address set to be
used when the system boots up; the second is the IP address
presently in use by the power supply. (The first address will
either be 0.0.0.0. if the Primary configuration is DHCP or
DHCP+AUTOIP, or it will be the static IP last specified).
N
SYST:NET:LANLED:BLINK
<string>
ON changes front panel screen to device identify.
OFF changes to dashboard screen.
N
SYST:NET:MAC?
Returns the network MAC address. xx:xx:xx:xx:xx:xx
(Hexadecimal digit pairs)
N
SYST:NET:MASK <string>
Set the network Subnet Mask for the device. String is in the
format “NNN.NNN.NNN.NNN”
where “NNN” = 0 through 255, inclusive.
N
SYST:NET:MASK?
Returns the network Subnet Mask for the device. N
SYST:NET:NETBUTTON <string>
Returns configuration parameters to factory default. (Software
equivalent of pressing the Reset switch on the rear panel of the
power supply). You must cycle the power to effect the change.
The access string is “6867.”
N
SYST:NET:PORT <NRf>
Set the network TCP/IP socket listening port. Valid values are
1025 to 65535.
N
SYST:NET:PORT?
Returns the network TCP/IP socket listening port. N