Asterion DC Multioutput Series
Programming Manual
11-100
M330517-01 Rev C
Minimum of 2 channels must enabled, inclusive of the reference channel to
configure the channels to work on Output ON/OFF Delay feature.
For example: If the user wants to enable channel 1 and channel 3 in this Output
ON/OFF feature user must send the SCPI command
(
SYSTem:PROGDELAY:ENABLE 1 3
).
If the user wants to enable channel 1, channel 2 and channel 3 in this
Output ON/OFF feature user must send the SCPI command
(
SYSTem:PROGDELAY:ENABLE 1 2 3
).
SYSTem:PROGDELAY:ENABLE?
// Returns the configured channels that are Enabled on
Output ON or OFF Delay feature.
Disable Channel:
Disable channel allows the user to disable the configurations to turn ON or OFF the
output on Output ON or OFF Delay feature. i.e., it Disable all the channels which are
enabled.
To disable the channels of the Output ON/OFF Delay can be set by sending the
following SCPI command using any of the interface available on the unit
(RS232,USB,LAN,GPIB):
SYSTem:PROGDELAY:DISABLE
Channel Delay:
The channel delay allows the user to set the channel’s delay to turn on or off the
output of the enabled channels with a specified delay time. Reference channel’s
delay and the non-selected channel should be programmed to 0.
To program the delay for the enabled channels, it can be set by sending the
following SCPI command using any of the interface available on the unit
(RS232,USB,LAN,GPIB):
SYSTem:PROGDELAY:DELAY <NRf>,<NRf>,<NRf>
For example: Reference channel is 1 and channels 1 and 2 are enabled,
SCPI:
SYSTem:PROGDELAY:DELAY 0,30,0
Arguments should be ( 0 (channel 1) , <delay for 2 channel> , 0 (channel 3) )
“Comma (,)” should be passed after each argument.
SYSTem:PROGDELAY:DELAY?
// Returns the programed delay for the channel that
were enabled.
Output ON/OFF State:
Output ON/OFF State allows the user to either turn ON or OFF the outputs of the
enabled channels with the delays specified. State 0 (OFF) allows the user to turn
OFF the channels output with programmed delay time. State 1 (ON) allows the user
to turn ON the channels output with programmed delay time.
To program the output state for the enabled channels, it can be set by sending the
following SCPI command using any of the interface available on the unit (RS232,
USB, LAN and GPIB):
SYSTem:PROGDELAY:OUTPut:STATe <boolean>
Summary of Contents for Sorensen Asterion DC ASM
Page 1: ...M330517 01 Rev C Asterion DC Multioutput Series Programming Manual...
Page 6: ...Asterion DC Multioutput Series Programming Manual M330517 01 Rev C v SAFETY SYMBOLS...
Page 145: ...Asterion DC Multioutput Series Programming Manual 13 128 M330517 01 Rev C CAL n LOCK...
Page 162: ...M330461 01 Rev C 14 145...
