Asterion DC Multioutput Series
Programming Manual
6-26
M330517-01 Rev C
6.4.2
Network Setup Using Auto-IP (Direct Connection
between Asterion power Supply and PC using Cross
cable)
This setup requires that DHCP and Auto-IP is ON (Refer to Figure 6-2). DHCP and Auto-
IP can be enabled using the front panel or the serial interface as described in the Section
6.4.1.1 and Section 6.4.1.2 respectively.
Since the setup is not connected to the DHCP server, Asterion DC Multioutput Series
power supply will assign itself an IP address in the IP address range from 169.254.0.1 to
169.254.255.254 with a subnet mask of 255.255.0.0.
6.4.2.1
IP
ADDRESS IDENTIFICATION FOR
A
UTO
-IP
MODE OF OPERATION
1. Start with the power supply in the power-off state.
2. Connect a crossover cable from the Asterion DC Multioutput Series power supply
directly to your PC.
3. If the PC is already configured to obtain an IP address automatically, skip to Step 4.
Otherwise:
a. In Windows click Start, Settings, Control Panel.
b. Click open Network Connections.
c. In the Network Connections window, right click the icon for the network adapter
used to connect to the power supply and click Properties.
d. Find the TCP/IP protocol item under the Configuration tab and click Properties.
Select Obtain an IP Address Automatically.
e. Click OK to save the change.
f. Click OK again to apply the settings to the network adapter.
4.
In Windows, click Start, and then Run…
5.
In the Run window, type “ipconfig /release” and click OK.
6.
Again, click Start, and then Run…
7.
In the Run window, type “ipconfig /renew” and click OK. Your PC will assign itself an
IP address in the Auto-IP range.
8. Power on the power supply and allow the power supply to perform its initialization.
9. Identify the IP address assigned to the power supply, refer Section 6.4.1.3.
10. The Asterion DC Multioutput Series power supply Ethernet hardware is now
configured. Open Web browser and enter the IP address of the power supply to view
the Home page. Refer to Figure 6-12.
6.4.3
Network Setup using Static IP
This setup requires that DHCP is OFF. DHCP mode can be made OFF using the front
Summary of Contents for Sorensen Asterion DC ASM
Page 1: ...M330517 01 Rev C Asterion DC Multioutput Series Programming Manual...
Page 6: ...Asterion DC Multioutput Series Programming Manual M330517 01 Rev C v SAFETY SYMBOLS...
Page 145: ...Asterion DC Multioutput Series Programming Manual 13 128 M330517 01 Rev C CAL n LOCK...
Page 162: ...M330461 01 Rev C 14 145...