Ametek Sorensen Asterion DC ASM, Programming Manual

Page: 57 / 162

Asterion DC Multioutput Series
Programming Manual
8-40
M330517-01 Rev C
Figure 8-2: Remote Analog Programming Interface Connector Pin-Out
Pin Signals Type Description
1 VPRG-VSOUR ANALOG INPUT
Remote control input for voltage programming using a voltage
source connected between this pin 1 and 3 signal return.
Signal return: Pin 3
Range: Full scale Voltage could be set by the user from 5V to
10V.
Input impedance: 20 kΩ, typical
2
VPRG-ISOUR ANALOG INPUT
Remote control input for voltage programming using a resistance
connected between this pin and signal return. Current Source of 1
mA is internally connected to this pin to enable resistance
programming.
Signal return: Pin 3
Range: Full scale Voltage could be set by the user from 5
kΩ to
10
kΩ.
Note: Do not exceed resistance of maximum 1
0 kΩ
3 PRG-RTN
PROGRAMMING
RETURN
Return for Pin 1 and 2.
Pin 3
– PRG-RTN is shorted with Pin 6 – MON-RTN internal to the
power supply.
4 IPRG-VSOUR ANALOG INPUT
Remote control input for current programming using a voltage
source connected between this pin and signal return.
Signal return: Pin 3
Range: Full scale Current could be set by the user from 5V to
10V.
Input impedance: 20 kΩ, typical
5 IPRG-ISOUR ANALOG INPUT
Remote control input for current programming using a resistance
connected between this pin and signal return. Current Source of 1
mA is connected to this pin from the power supply to enable
resistance programming.
Signal return: Pin 3
Range: Full scale Current could be set by the user from 5
kΩ to
10
kΩ.
Note: Do not exceed resistance of maximum 1
0 kΩ