Asterion DC Multioutput Series
Programming Manual
M330517-01 Rev C
6-25
6.4.1.3
IP
ADDRESS IDENTIFICATION FOR
DHCP
MODE OF OPERATION
1.
Start with the power supply in the power-off state.
2. Connect a RJ-45 network cable from the power supply to the network with the DHCP
server.
3. Power on the power supply and allow the power supply to perform its initialization.
4. Identify the IP address assigned to the power supply by accessing the DHCP server,
by any of four ways:
a) Asking your network administrator.
b) Discovering it with a VXI-11 compliant discover program.
NOTE:
The power supply is VXI-11 compliant, so even without access to the
DHCP server, it is still possible to discover the IP address assigned to the
power supply with programs such as National Instrument’s NI-VISA.
c) Using front panel and navigating to Home
→
Control Interface
→
LAN
→
LAN
Settings. Refer to Figure 6-4.
Figure 6-4: LAN Screen (Settings)
d) Using a computer serial communications program such as Tera Term, set for the
same baud rate as Asterion DC Multioutput Series power supply (Refer to Section
4.2.2) no parity, 8 data bits, 1 stop bit. Use SCPI command
SYST:NET:IP?
to get
the IP address.
To find RS232 Settings of the power supply, navigate to Home
→
Control Interface
→
RS232
→
RS232 Settings, Refer to Figure 6-5.
Figure 6-5: RS232 Screen (Settings)
5. The power supply hardware is now configured. Open Web browser and enter the IP
address of the power supply to view the Home page of the power supply. Refer to
Figure 6-12.
Summary of Contents for Sorensen Asterion DC ASM
Page 1: ...M330517 01 Rev C Asterion DC Multioutput Series Programming Manual...
Page 6: ...Asterion DC Multioutput Series Programming Manual M330517 01 Rev C v SAFETY SYMBOLS...
Page 145: ...Asterion DC Multioutput Series Programming Manual 13 128 M330517 01 Rev C CAL n LOCK...
Page 162: ...M330461 01 Rev C 14 145...
