Ametek Sorensen Asterion DC ASM, Programming Manual

Page: 99 / 162

Asterion DC Multioutput Series
Programming Manual
10-82
M330517-01 Rev C
Command Description SCPI
SYST:NET:TERM <NRf>
Sets the incoming string termination character to be used by the
device. Factory set to 3. The valid range is 1-4. Values indicate
the following terminator(s):
1 = 0x0d only (CR), 2 = 0x0a only (LF), 3 = 0x0d 0x0a (CR LF),
4 = 0x0a 0x0d (LF CR)
N
SYST:NET:TERM?
Returns the string terminators to be used by the device. N
HTRIGGER SCPI Command Subsystem
The HTRIGGER function allows the user to apply an External User Interface input signal
to initiate a sequence or a voltage or current ramp. Once a hardware trigger is run, Arm
goes to 0 (not armed); however, the last loaded sequence remains in memory.
10.9.1
HTRIGGER SCPI Command Summary
HTRIGger<n>
:ABORt
10.9.2
HTRIGGER SCPI Command Reference
Command Description SCPI
HTRIGger<n>
:ABORt
Stops the execution of a currently running hardware trigger
function. In addition:
For Ramp: Clears all settings of voltage and current.
For Sequence: Sets the Arm function to 0 (not armed).
N
TRIGGER SCPI Command Subsystem
This section describes the programming soft trigger function.
10.10.1
TRIGGER SCPI Command Summary
TRIGger<n>
:ABORt
:RAMP
:TYPE <1|2|3>
10.10.2
TRIGGER SCPI Command Reference
The letter “C” in the “SCPI” column means that the command syntax is SCPI compliant;
an “N” in the “SCPI” column means that the command syntax is not part of the SCPI
definition.
Command Description SCPI
TRIGger<n>
:ABORt
Stops the execution of a currently running trigger function and
clears all settings of voltage and current.
N
TRIGger<n>
:RAMP
Executes voltage or current ramping function previously
programmed by the SOURce command, i.e.,
SOURce<n>:VOLTage:RAMP:TRIG
SOURce<n>:CURRent:RAMP:TRIG
N