606
Command Reference for AT-IX5-28GPX High Availability, High Power Video Surveillance PoE Switch
C613-50057-01 REV A
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
IP A
DDRESSING
AND
P
ROTOCOL
C
OMMANDS
ARP
(IP
ADDRESS
MAC)
arp (IP address MAC)
Overview
This command adds a static ARP entry to the ARP cache. This is typically used to
add entries for hosts that do not support ARP or to speed up the address resolution
function for a host. The ARP entry must not already exist. Use the
alias
parameter
to allow your device to respond to ARP requests for this IP address.
The
no
variant of this command removes the static ARP entry. Use the
clear
arp-cache
command to remove the dynamic ARP entries in the ARP cache.
Syntax
arp <
ip-addr
> <
mac-address
> [<
port-number
>] [alias]
no arp <
ip-addr
>
Mode
Global Configuration
Examples
To add the IP address 10.10.10.9 with the MAC address 0010.2533.4655 into the
ARP cache, and have your device respond to ARP requests for this address, use the
commands:
awplus#
configure terminal
awplus(config)#
arp 10.10.10.9 0010.2355.4566 alias
Related
Commands
clear arp-cache
ip proxy-arp
show arp
Parameter
Description
<ip-addr>
IPv4 address of the device you are adding
as a static ARP entry.
<mac-address>
MAC address of the device you are adding as a static ARP
entry, in hexadecimal notation with the format
HHHH.HHHH.HHHH.
<port-number>
The port number associated with the IP address. Specify this
when the IP address is part of a VLAN.
alias
Allows your device to respond to ARP requests for the IP
address. Proxy ARP must be enabled on the interface before
using this parameter.