14
562
Command Reference for AT-IX5-28GPX High Availability, High Power Video Surveillance PoE Switch
C613-50057-01 REV A
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
Power over
Ethernet
Commands
Introduction
Overview
This chapter contains an alphabetical list of commands used to configure Power
over Ethernet (PoE). Each command contains a functional description and shows
examples of configuration and output screens for show commands. These
commands are only supported on PoE capable ports. An error message will display
on the console if you enter a PoE command on a port that does not support PoE.
The following documents offer further information for configuring PoE on
AlliedWare Plus switches.
•
the
PoE Feature Overview and Configuration Guide
.
•
the
SNMP MIBs Overview
, for information about which PoE MIB objects are
supported.
•
the
SNMP Feature Overview and Configuration Guide
, for information about
SNMP traps.
Power over Ethernet (PoE) is a technology allowing devices such as IP phones to
receive power over existing LAN cabling.
PoE is configured using the commands in this chapter. Note the Power Sourcing
Equipment (PSE) referred to throughout this chapter is an Allied Telesis PoE switch
running the AlliedWare Plus™ Operating System, supporting the IEEE 802.3af and
IEEE 802.3at Power Ethernet standards. The Powered Device (PD) referred to
throughout this chapter is a PoE or PoE+ powered device, such as an IP phone or a
Wireless Access Point (WAP).
The commands in this chapter are available on the Allied Telesis IX5-28GPX switch.
IX5-28GPX switches are Layer 2 PoE+ Gigabit Ethernet switches with SFP+ support.
NOTE
:
Note that IX5-28GPX Layer 2 Gigabit Ethernet PoE+ switches with SFP / SFP+
support can have one or two hot-swappable AT-PWR800 (800 W) power supplies
installed.
See the
IX5 Series Installation Guide
for information about PSU options.
NOTE
:
