338
Command Reference for AT-IX5-28GPX High Availability, High Power Video Surveillance PoE Switch
C613-50057-01 REV A
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
I
NTERFACE
C
OMMANDS
SHOW
INTERFACE
STATUS
show interface status
Overview
Use this command to display the status of the specified interface or interfaces.
Note that when no interface or interfaces are specified then the status of all
interfaces on the device are shown.
Syntax
show interface [<
port-list
>] status
Examples
To display the status of ports 1.0.1 to 1.0.5, use the commands:
awplus#
show interface port1.0.1-1.0.4 status
Parameter
Description
<port-list>
The ports to display information about. The port list can be:
•
a switch port (e.g.
port1.0.6
) a static channel group (e.g.
sa2
) or
a dynamic (LACP) channel group (e.g.
po2
)
•
a continuous range of ports separated by a hyphen, e.g.
port1.0.1-1.0.6
, or
sa1-2
, or
po1-2
•
a comma-separated list of ports and port ranges, e.g.
port1.0.1,port1.0.4-1.0.6
. Do not mix switch ports,
static channel groups, and dynamic (LACP) channel groups in the
same list
Table 8-2: Example output from the
show interface <port-list> status
command
awplus#show interface port1.0.1 -1.0.5 status
Port Name Status Vlan Duplex Speed Type
port1.0.1 notconnect 1 auto auto 1000BASE-T
port1.0.2 notconnect 1 auto auto 1000BASE-T
port1.0.3 notconnect 1 auto auto 1000BASE-T
port1.0.4 notconnect 1 auto auto 1000BASE-T
