1490
Command Reference for AT-IX5-28GPX High Availability, High Power Video Surveillance PoE Switch
C613-50057-01 REV A
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
AMF C
OMMANDS
SHOW
ATMF
GROUP
A typical output screen from this command is shown below:
This confirms that the six nodes (
node1
to
node6
) are now members of the
working-set and that these nodes reside within the
AMF-NETWORK
.
Note that to run this command, you must have previously entered the command
atmf working-set
on page 1461. This can be seen from the network level prompt,
which in this case is
AMF_NETWORK[6]#
.
ATMF group information
master, poe, x8100
===============================================
node1, node2, node3, node4, node5, node6:
===============================================
ATMF group information
sysadmin, x8100
AMF_NETWORK[6]#
Table 37-17: Sample output from the
show atmf group
command for a working
set.
AMF_NETWORK[6]#show atmf group
===============================
node3, node4, node5, node6:
===============================
ATMF group information
edge_switches, x510
Table 37-18: Parameter definitions from the
show atmf group
command for a
working set
Parameter
Definition
ATMF group information
Displays a list of nodes and the groups that they
belong to, for example:
•
master - Shows a common group name for Nodes
configured as AMF masters.
•
Hardware Arch - Shows a group for all Nodes
sharing a common Hardware architecture, e.g.
x8100, x610, for example.
•
User-defined - Arbitrary groups created by the
user for AMF nodes.
