Agilent Technologies DSO-X 4022A, User Manual

Page: 398 / 488

398 Agilent InfiniiVision 4000 X-Series Oscilloscopes User's Guide
23
CAN/LIN Triggering and Serial Decode
2 In the Trigger Menu, press the Trigger softkey; then, turn the Entry knob
to select the serial slot (Serial 1 or Serial 2) on which the CAN signal
is being decoded.
3
Press the
Trigger:
softkey; then, turn the Entry knob to select the trigger
condition:
• Sync (Sync Break) — The oscilloscope triggers on the rising edge at
the Sync Break exit of the LIN single- wire bus signal that marks the
beginning the message frame.
•
ID
(Frame ID) — The oscilloscope triggers when a frame with an ID
equal to the selected value is detected. Use the Entry knob to select
the value for the Frame ID.
•
ID & Data
(Frame ID and Data) — The oscilloscope triggers when a
frame with an ID and data equal to the selected values is detected.
When triggering on a frame ID and data:
• To select the frame ID value, press the Frame ID softkey, and use
the
Entry
knob.
Note that you can enter a "don't care" value for the frame ID and
trigger on data values only.
• To set up the number of data bytes and enter their values (in
hexadecimal or binary), press the
Bits
softkey to open the LIN Bits
Menu.