Agilent Technologies DSO-X 4022A, User Manual

Page: 330 / 488

330 Agilent InfiniiVision 4000 X-Series Oscilloscopes User's Guide
20
Utility Settings
• LAN — When connected to a LAN, you can use the LAN Settings and
LAN Reset softkeys to configure the LAN interface. See "Setting up the
Oscilloscope's LAN Connection" on page 330.
• There are no configuration settings for the USB interface.
When an I/O interface is installed, remote control over that interface is
always enabled. Also, the oscilloscope can be controlled via multiple I/O
interfaces (for example, USB and LAN) at the same time.
See Also • Chapter 21 , “Web Interface,” starting on page 349 (when the
oscilloscope is connected to a LAN).
• "Remote Programming via the Web Interface" on page 355
• The oscilloscope's Programmer's Guide .
• "Remote Programming with Agilent IO Libraries" on page 356
Setting up the Oscilloscope's LAN Connection
Using the rear panel LAN port, you can place the oscilloscope on the
network and set up its LAN connection. Once that is done, you can set up
and use network printers or use the oscilloscope's web interface or
remotely control the oscilloscope via the LAN interface.
The oscilloscope supports methods for automated LAN configuration or
manual LAN configuration (see
"To establish a LAN connection" on
page 331). It is also possible to set up a point- to- point LAN connection
between a PC and the oscilloscope (see
"Stand- alone (Point- to- Point)
Connection to a PC" on page 332).
Once the oscilloscope is set up on the network, you can use the
oscilloscope's web page to view or change its network configuration and
access additional settings (like the network password). See
Chapter 21 ,
“Web Interface,” starting on page 349.
N O T E
When you connect the oscilloscope to a LAN it is a good practice to limit access to the
oscilloscope by setting a password. By default, the oscilloscope is not password protected.
See
"Setting a Password" on page 363 to set a password.