Agilent Technologies DSO-X 4022A, User Manual

Page: 331 / 488

Utility Settings
20
Agilent InfiniiVision 4000 X-Series Oscilloscopes User's Guide 331
To establish a LAN connection
Automatic
Configuration
1 Press [Utility] > I/O .
2 Press the LAN Settings softkey.
3 Press the Config softkey; then, turn the Entry knob to select Automatic ,
and press the softkey again to enable it.
If your network supports DHCP or AutoIP, enabling Automatic lets the
oscilloscope use those services to get its LAN configuration settings
4 If your network provides Dynamic DNS, you can enable the Dynamic DNS
option to let the oscilloscope register its hostname and use the DNS
server for name resolution.
5 You can enable the Multicast DNS option to let the oscilloscope use
Multicast DNS for name resolution on small networks without a
conventional DNS server.
6 Connect the oscilloscope to the local area network (LAN) by inserting
the LAN cable into the "LAN" port on the rear panel of the
oscilloscope.
In a few moments the oscilloscope will connect to the network
automatically.
If the oscilloscope does not automatically connect to the network, press
[Utility] > I/O > LAN Reset
. In a few moments the oscilloscope will connect
to the network.
Manual
Configuration
1 Get the oscilloscope's network parameters (host name, IP address,
subnet mask, gateway IP, DNS IP, etc.) from your network
administrator.
2 Press [Utility] > I/O .
3 Press the LAN Settings softkey.
4 Press the Config softkey; then, turn the Entry knob to select Automatic ,
and press the softkey again to disable it.
N O T E
Any time you modify the oscilloscope's hostname, it breaks the connection between the
oscilloscope and the LAN. You need to re-establish communication to the oscilloscope
using the new hostname.