Agilent Technologies DSO-X 4022A, User Manual

Page: 332 / 488

332 Agilent InfiniiVision 4000 X-Series Oscilloscopes User's Guide
20
Utility Settings
If Automatic is not enabled, the oscilloscope's LAN configuration must
be set up manually using the
Modify and Host name softkeys
5
Configure the oscilloscope's LAN interface:
a
Use the
Modify
softkey (and the other softkeys and keypad entry
dialogs) to enter the IP Address, Subnet Mask, Gateway IP, and DNS
IP values.
b
Press the
Host name
softkey and use the keypad entry dialog to enter
the Host Name.
c Press the Apply softkey.
6 Connect the oscilloscope to the local area network (LAN) by inserting
the LAN cable into the "LAN" port on the rear panel of the
oscilloscope.
Stand-alone (Point-to-Point) Connection to a PC
The following procedure describes how to establish a point- to- point (stand
alone) connection to the oscilloscope. This is useful if you want to control
the oscilloscope using a laptop computer or a stand- alone computer.
1
Press
[Utility] > I/O
.
2
Press the
LAN Settings
softkey.
3
Press the
Config
softkey; then, turn the Entry knob to select
Automatic
,
and press the softkey again to enable it.
If your network supports DHCP or AutoIP, enabling Automatic lets the
oscilloscope use those services to get its LAN configuration settings
4
Connect your PC to the oscilloscope using a cross- over LAN cable such
as Agilent part number 5061- 0701, available on the web at
"www.parts.agilent.com" .
5
Cycle power on the oscilloscope. Wait until the LAN connection is
configured:
• Press [Utility] > I/O and wait until the LAN status shows "configured".
This may take a few minutes.
Now, the instrument is connected, and the instrument's web interface or
remote control via LAN may be used.