Agilent Technologies DSO-X 4022A, User Manual

Page: 33 / 488

Getting Started
1
Agilent InfiniiVision 4000 X-Series Oscilloscopes User's Guide 33
Recall the Default Oscilloscope Setup
To recall the default oscilloscope setup:
1 Press [Default Setup] .
The default setup restores the oscilloscope's default settings. This places
the oscilloscope in a known operating condition. The major default settings
are:
In the Save/Recall Menu, there are also options for restoring the complete
factory settings (see
“Recalling Default Setups" on page 321) or performing
a secure erase (see “Performing a Secure Erase" on page 321).
Use Auto Scale
Use
[Auto Scale]
to automatically configure the oscilloscope to best display
the input signals.
1 Press [Auto Scale] .
You should see a waveform on the oscilloscope's display similar to this:
Table 2 Default Configuration Settings
Horizontal Normal mode, 100 µs/div scale, 0 s delay, center time reference.
Vertical (Analog)
Channel 1 on, 5 V/div scale, DC coupling, 0 V position, 1 M
Ω
impedance.
Trigger Edge trigger, Auto trigger mode, 0 V level, channel 1 source, DC coupling,
rising edge slope, 40 ns holdoff time.
Display Persistence off, 20% grid intensity, 50% waveform intensity.
Other Acquire mode normal, [Run/Stop] to Run, cursors and measurements off.
Labels All custom labels that you have created in the Label Library are preserved (not
erased), but all channel labels will be set to their original names.