
262 Parameters
Source selection (see
on page
). -
Defines the time inside which the extra time is deactivated
after extra time activation signal is switched off.
Example:
set to
is set to 00 01:30,
the extra time is active for 1 hour and 30 minutes after digital
input DI is deactivated.
00 00:00
00 00:00…00 00:00 Extra time duration.
1 = 1
35
Motor thermal protection settings such as temperature
measurement configuration, load curve definition and motor
fan control configuration.
See also section
(page
Displays the motor temperature as estimated by the internal
motor thermal protection model (see parameters
). The unit is selected by parameter
This parameter is read-only.
-
-60…1000 °C or
-76…1832 °F
Estimated motor temperature.
1 = 1°
Displays the temperature received through the source
defined by parameter
. The unit is
.
Note:
With a PTC sensor, the value shown is not a valid
measurement. Either 0 ohm (normal temperature) or the
value of parameter
(excessive
temperature) is shown.
This parameter is read-only.
-
-60…5000 °C or
-76…9032 °F,
0 ohm or
[
Measured temperature 1.
1 = 1 unit
Displays the temperature received through the source
defined by parameter
. The unit
Note:
With a PTC sensor, the value shown is not a valid
measurement. Either 0 ohm (normal temperature) or the
value of parameter
(excessive
temperature) is shown.
This parameter is read-only.
-
-60…5000 °C or
-76…9032 °F,
0 ohm or
[
Measured temperature 2.
1 = 1 unit
Selects the source from which measured temperature 1 is
read.
Usually this source is from a sensor connected to the motor
controlled by the drive, but it could be used to measure and
monitor a temperature from other parts of the process as long
as a suitable sensor is used as per the selection list.
Disabled
None. Temperature monitoring function 1 is disabled.
0
No.
Name/Value
Description
Def/FbEq16
ACS580 FW.book Page 262 Wednesday, September 21, 2016 9:48 PM