ABB ACS580 Series, Firmware Manual

Page: 335 / 462

Parameters 331
Timed function 1 Bit 0 of 34.01 Timed functions status (see page 255 ). 18
Timed function 2 Bit 1 of 34.01 Timed functions status (see page 255 ). 19
Timed function 3 Bit 2 of 34.01 Timed functions status (see page 255 ). 20
Reserved 21…23
Supervision 1 Bit 0 of 32.01 Supervision status (see page 248 ). 24
Supervision 2 Bit 1 of 32.01 Supervision status (see page 248 ). 25
Supervision 3 Bit 2 of 32.01 Supervision status (see page 248 ). 26
Other [bit] Source selection (see Terms and abbreviations on page 144 ). -
96.13 User set I/O mode
in2 See parameter 96.12 User set I/O mode in1 . Not selected
96.16 Unit selection Selects the unit of parameters indicating power, temperature
and torque. 0000b
0000h…FFFFh Unit selection word. 1 = 1
96.51 Clear fault and
event logger Clears all events from the drive’s fault and event logs. Done
Done 1 = No action 0
Clear 1 = Clear the loggers. 1
0…1 1 = 1
96.100 Change user pass
code
(Visible when user lock is open)
To change the current user pass code, enter a new code into
this parameter as well as
96.101 Confirm user pass code . A
warning will be active until the new pass code is confirmed.
To cancel changing the pass code, close the user lock without
confirming. To close the lock, enter an invalid pass code in
parameter
96.02 Pass code , activate parameter 96.08
Control board boot , or cycle the power.
See also section User lock (page 140 ).
10000000
10000000…
99999999 New user pass code. -
96.101 Confirm user pass
code
(Visible when user lock is open)
Confirms the new user pass code entered in 96.100 Change
user pass code .
10000000…
99999999 Confirmation of new user pass code. -
No. Name/Value Description Def/FbEq16
Bit Name Information
0 Power unit 0 = kW
1 = hp
1 Reserved
2 Temperature
unit 0 = °C
1 = °F
3 Reserved
4 Torque unit 0 = Nm (N·m)
1 = lbft (lb·ft)
5…15 Reserved
ACS580 FW.book Page 331 Wednesday, September 21, 2016 9:48 PM