ZyXEL Communications GS1920-48HPv2, Руководство пользователя

Страница: 377 / 432

Chapter 44 Cluster Management
GS1920v2 Series User’s Guide
377
44.3 C luste ring Ma na g e m e nt C o nfig ura tio n
Use this screen to configure clustering management. Click
Ma na g e m e nt
>
C luste r Ma na g e m e nt
>
C o nfig ura tio n
to display the next screen.
Fig ure 277
Management > Cluster Management > Configuration
The following table describes the labels in this screen.
Table 188 Management > Cluster Management > Configuration
LABEL DESC RIPTIO N
Clustering Manager
Active Select
Ac tive
to have this Switch become the cluster manager switch. A cluster can only
have one manager. Other (directly connected) switches that are set to be cluster
managers will not be visible in the
C luste ring C a ndida te s
list. If a switch that was previously a
cluster member is later set to become a cluster manager, then its
Sta tus
is displayed as
Erro r
in the
C luste r Ma na g e m e nt Sta tus
screen and a warning icon ( ) appears in the member
summary list below.
Name Type a name to identify the
C luste ring Ma na g e r.
You may use up to 32 printable characters
(spaces are allowed).
VID This is the VLAN ID and is only applicable if the Switch is set to
802.1Q
VLAN. All switches must
be directly connected and in the same VLAN group to belong to the same cluster. Switches
that are not in the same VLAN group are not visible in the
C luste ring C a ndida te s
list. This
field is ignored if the
C luste ring Ma na g e r
is using
Po rt- b a se d
VLAN.
Apply Click
Apply
to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the
Sa ve
link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.