ZyXEL Communications GS1920-48HPv2, Руководство пользователя

Страница: 302 / 432

Chapter 33 Link Layer Discovery Protocol (LLDP)
GS1920v2 Series User’s Guide
302
33.7 LLDP- MED C o nfig ura tio n
Click
Adva nc e d Applic a tio n
>
LLDP > LLDP- MED C o nfig ura tio n
to display the screen as shown next.
Fig ure 217
Advanced Application > LLDP > LLDP-MED Configuration
Port VLAN ID Select the check box(es) to enable or disable the sending of IEEE 802.1 Port VLAN ID TLVs on
the port(s). All check boxes in this column are enabled by default.
Dot3 TLV
Link
Aggregation
Select the check box(es) to enable or disable the sending of IEEE 802.3 Link Aggregation TLVs
on the port(s).
MAC/PHY Select the check box(es) to enable or disable the sending of IEEE 802.3 MAC/PHY
Configuration/Status TLVs on the port(s). All check boxes in this column are enabled by
default.
Max Frame Size Select the check box(es) to enable or disable the sending of IEEE 802.3 Max Frame Size TLVs
on the port(s).
Power Via MDI
No te
: For PoE models only. The Power Via MDI TLV allows network management to advertise
and discover the MDI power support capabilities of the sending port on the remote device.
• Port Class
• MDI Supported
• MDI Enabled
• Pair Controlable
• PSE Power Pairs
• Power Class
Apply Click
Apply
to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the
Sa ve
link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Cancel Click
C a nc e l
to begin configuring this screen afresh.
Table 140 Advanced Application > LLDP > LLDP Configuration > Org-specific TLV Setting
LABEL DESC RIPTIO N