ZyXEL Communications GS1920-48HPv2, Руководство пользователя

Страница: 228 / 432

Chapter 25 AAA
GS1920v2 Series User’s Guide
228
25.4 TAC AC S+ Se rve r Se tup
Use this screen to configure your server settings. See RADIUS and on page 226 for
more information on servers. Click on the
TAC AC S+ Se rve r Se tup
link in the
AAA
screen to view
the screen as shown.
Delete Check this box if you want to remove an existing RADIUS server entry from the Switch. This entry
is deleted when you click
Apply
.
Accounting
Server Use this section to configure your RADIUS accounting server settings.
Timeout Specify the amount of time in seconds that the Switch waits for an accounting request
response from the RADIUS accounting server.
Index This is a read-only number representing a RADIUS accounting server entry.
IP Address Enter the IP address of an external RADIUS accounting server in dotted decimal notation.
UDP Port The default port of a RADIUS accounting server for accounting is
1813
. You need not change
this value unless your network administrator instructs you to do so.
Shared Secret Specify a password (up to 32 alphanumeric characters) as the key to be shared between the
external RADIUS accounting server and the Switch. This key is not sent over the network. This key
must be the same on the external RADIUS accounting server and the Switch.
Delete Check this box if you want to remove an existing RADIUS accounting server entry from the
Switch. This entry is deleted when you click
Apply
.
Apply Click
Apply
to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the
Sa ve
link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Cancel Click
C a nc e l
to begin configuring this screen afresh.
Table 94 Advanced Application > AAA > RADIUS Server Setup (continued)
LABEL DESC RIPTIO N