ZyXEL Communications GS1920-48HPv2, Руководство пользователя

Страница: 168 / 432

Chapter 17 Link Aggregation
GS1920v2 Series User’s Guide
168
17.4 Te c hnic a l Re fe re nc e
This section provides technical background information on the topics discussed in this chapter.
17.4.1 Sta tic Trunking Exa m ple
This example shows you how to create a static port trunk group for ports 2-5.
1 Ma ke yo ur physic a l c o nne c tio ns
- make sure that the ports that you want to belong to the trunk group
are connected to the same destination. The following figure shows ports 2-5 on switch
A
connected to
switch
B
.
Fig ure 125
Trunking Example - Physical Connections
System Priority LACP system priority is a number between 1 and 65,535. The switch with the lowest system priority
(and lowest port number if system priority is the same) becomes the LACP “server”. The LACP
“server” controls the operation of LACP setup. Enter a number to set the priority of an active port
using Link Aggregation Control Protocol (LACP). The smaller the number, the higher the priority
level.
Group ID The field identifies the link aggregation group, that is, one logical link containing multiple ports.
LACP Active Select this option to enable LACP for a trunk.
Port This field displays the port number.
* Settings in this row apply to all ports.
Use this row only if you want to make some settings the same for all ports. Use this row first to set
the common settings and then make adjustments on a port-by-port basis.
Note: Changes in this row are copied to all the ports as soon as you make them.
LACP Timeout Timeout is the time interval between the individual port exchanges of LACP packets in order to
check that the peer port in the trunk group is still up. If a port does not respond after three tries,
then it is deemed to be “down” and is removed from the trunk. Set a short timeout (one second)
for busy trunked links to ensure that disabled ports are removed from the trunk group as soon as
possible.
Select either 1 second or 30 seconds.
Apply Click
Apply
to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the
Sa ve
link on the top navigation panel to save
your changes to the non-volatile memory when you are done configuring.
Cancel Click
C a nc e l
to begin configuring this screen afresh.
Table 65 Advanced Application > Link Aggregation > Link Aggregation Setting > LACP (continued)
LABEL DESC RIPTIO N